Husqvarna 966659502, EZ4824TF BF warranty Press in and turn the ignition key to the start position

Page 28

OPERATION

8.Press in and turn the ignition key to the start position.

IMPORTANT INFORMATION

Do not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds before retrying.

Turn to the start position

8050-7432

9.When the engine starts, immediately release the ignition key back to the run position. Push the choke control in gradually when the engine has started.

WARNING!

Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces.

10.Set the engine speed with the throttle. Allow the engine to run at a moderate speed, approximately mid throttle, for 3-5 minutes before loading it too heavily. USE FULL THROTTLE WHEN MOWING (no choke).

Return to run position

8050-7432

8058-148

Set the engine speed

28

Image 28

Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Cutting Height Adjuster Seat Adjustment LeverFuel Shut Off Valve Always raise the deck to the highest position for transportTracking Knob Hour MeterBypass Linkages Training OperationSteering Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position Jumper Cables Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine by Hand Maintenance Maintenance ScheduleMaintenance interval Daily Least Hours Once Before AfterMaintenance Daily Once Hours Each Before After 100 300Battery Replacing batterySafety System Tire PressuresBelts Deck Belt RemovalBelt installation Pump Belt Replacing pump beltBlade replacement Cutting BladesAdjusting the Mower Deck Leveling deckHardware Caster WheelsAnti-Scalp Rollers Cleaning Use protective glasses when cleaning and washingLubrication GeneralWheel and Deck Zerks Front Wheel MountFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Troubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematics Technical Data Torque SpecificationsAccessories Standard HardwareDimension EZ4824T BF \Engine TransmissionConformity Certificates USA requirementsDelivery Service Action Date, mtr reading, stamp, signHour Service After the first 5-8 hoursService Journal At Least Once Each Year Page 115 505927 Rev B 2012-07-30