Husqvarna 966659502, EZ4824TF BF warranty Ignition Switch, Choke Control, Fuses

Page 20

CONTROLS

Ignition Switch

The ignition switch is placed on the control panel and is used to start and stop the engine.

Choke Control

The choke control is used for cold starts in to provide the engine with a richer fuel mixture.

For cold starts the control should be pulled out.

Fuses

Fuses are located under the seat of the machine. They are accessed by tilting the seat forward. They are flat pin fuses of the same type used in automobiles.

There are two fuses with ratings and functions:

20 Amp Primary fuse

7.5 Amp Mower deck coupling

8058-134

Ignition switch

8058-134

Choke control

8011-420

Fuses

20

Image 20

Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark Arrestor Controls Control LocationsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Cutting Height Adjuster Seat Adjustment LeverFuel Shut Off Valve Always raise the deck to the highest position for transportBypass Linkages Hour MeterTracking Knob Steering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine by Hand Maintenance Maintenance ScheduleMaintenance interval Daily Least Hours Once Before AfterMaintenance Daily Once Hours Each Before After 100 300Battery Replacing batterySafety System Tire PressuresBelts Deck Belt RemovalBelt installation Pump Belt Replacing pump beltBlade replacement Cutting BladesAdjusting the Mower Deck Leveling deckAnti-Scalp Rollers Caster WheelsHardware Cleaning Use protective glasses when cleaning and washingLubrication GeneralWheel and Deck Zerks Front Wheel MountFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Troubleshooting Problem CauseTroubleshooting Winter Storage ServiceStorage Schematics Technical Data Torque SpecificationsAccessories Standard HardwareDimension EZ4824T BF \Engine TransmissionConformity Certificates USA requirementsDelivery Service Action Date, mtr reading, stamp, signHour Service After the first 5-8 hoursService Journal At Least Once Each Year Page 115 505927 Rev B 2012-07-30