Husqvarna EZ4824TF BF, 966659502 warranty Cutting Blades, Blade replacement

Page 41

MAINTENANCE

Cutting Blades

To attain the best mowing effect, it is important that blades are well sharpened and not damaged.

Replace blades that have been bent or cracked when hitting obstacles.

IMPORTANT INFORMATION

The sharpening of blades should be carried out by an authorized service workshop.

Let the service workshop decide whether a blade with large nicks can be repaired/ground or must be replaced. Balance the blades after sharpening.

Check the blade mounts.

WARNING!

Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling.

8011-604-1

Check the blades

Blade replacement

1.Remove blade bolt by turning counterclockwise.

2.Install new or resharpened blade with stamped GRASS SIDE facing towards ground/grass (down) or THIS SIDE UP facing deck and cutter housing.

3.Install and tighten blade bolt securely.

4.Torque blade bolt to 90 ft/lbs (122 Nm).

IMPORTANT INFORMATION Special blade bolt is heat treated. Replace with a Husqvarna bolt if required.

Do not use lower grade hardware than specified.

13

2

8061-022

1.Blade

2.Blade bolt (special)

3.Cutter housing Blade attachment

41

Image 41

Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Performing any Safety Instructions SafetyNever take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Seat Adjustment Lever Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportBypass Linkages Hour MeterTracking Knob Steering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine by Hand Maintenance Schedule MaintenanceMaintenance interval Daily Least Hours Once Before AfterDaily Once Hours Each Before After 100 300 MaintenanceReplacing battery Battery Tire Pressures Safety SystemDeck Belt Removal BeltsPump Belt Replacing pump belt Belt installationCutting Blades Blade replacementLeveling deck Adjusting the Mower DeckAnti-Scalp Rollers Caster WheelsHardware Use protective glasses when cleaning and washing CleaningGeneral LubricationFront Wheel Mount Wheel and Deck ZerksFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Problem Cause TroubleshootingTroubleshooting Winter Storage ServiceStorage Schematics Torque Specifications Technical DataAccessories Standard HardwareEZ4824T BF \ DimensionEngine TransmissionUSA requirements Conformity CertificatesAction Date, mtr reading, stamp, sign Delivery ServiceAfter the first 5-8 hours Hour ServiceService Journal At Least Once Each Year Page 115 505927 Rev B 2012-07-30