Husqvarna EZ4824TF BF, 966659502 Weak Battery, Jumper Cables, To remove cables, reverse order

Page 29

OPERATION

Weak Battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles.

If your battery is too weak to start the engine, it should be recharged. (See Battery in the Maintenance section.)

Jumper Cables

1.	Connect each end of the RED cable to the
	POSITIVE (+) terminal on each battery, taking
	care not to short against chassis.
2.	Connect one end of the BLACK cable to the
	NEGATIVE (-) terminal of the fully charged battery.	8011-642
3.	Connect the other end of the BLACK cable to a	Jumper cable connection
	good CHASSIS GROUND on the mower with the
	discharged battery, away from the fuel tank and
	battery.

To remove cables, reverse order

4.Remove BLACK cable first from chassis and then from the fully charged battery.

5.Remove RED cable last from both batteries.

29

Image 29

Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Performing any Safety Instructions SafetyNever take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Seat Adjustment Lever Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportBypass Linkages Hour MeterTracking Knob Steering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine by Hand Maintenance Schedule MaintenanceMaintenance interval Daily Least Hours Once Before AfterDaily Once Hours Each Before After 100 300 MaintenanceReplacing battery BatteryTire Pressures Safety SystemDeck Belt Removal BeltsPump Belt Replacing pump belt Belt installationCutting Blades Blade replacementLeveling deck Adjusting the Mower DeckAnti-Scalp Rollers Caster WheelsHardware Use protective glasses when cleaning and washing CleaningGeneral LubricationFront Wheel Mount Wheel and Deck ZerksFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Problem Cause TroubleshootingTroubleshooting Winter Storage ServiceStorage Schematics Torque Specifications Technical DataAccessories Standard HardwareEZ4824T BF \ DimensionEngine TransmissionUSA requirements Conformity CertificatesAction Date, mtr reading, stamp, sign Delivery ServiceAfter the first 5-8 hours Hour ServiceService Journal At Least Once Each Year Page 115 505927 Rev B 2012-07-30