Husqvarna 966659502 warranty Fuel Shut Off Valve, Cutting Height Adjuster, Seat Adjustment Lever

Page 22

CONTROLS

Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of the seat. The valve is off when the handle tab is turned perpendicular to the fuel line.

IMPORTANT INFORMATION

Always raise the deck to the highest position for transport.

Cutting Height Adjuster

The deck cutting height is obtained by pressing the button and moving the lever forward to the correct cutting height on the cutting plate. The cutting height range is from 1½" (38mm) to 4" (102mm) in ½ (13mm) increments. The heights are measured from the ground up to the blade tip with the engine not running.

IMPORTANT INFORMATION

To obtain an even cutting height, it is important that the air pressure in all tires is 15 psi / 103 kPa / 1 bar.

Seat Adjustment Lever

The seat can be adjusted lengthways. When making adjustments, the lever under the right front side of the seat is pulled to the side, after which the seat can be moved backward or forward.

8011-419

Fuel shut off valve in the CLOSED position

8058-019

The mower deck’s lifting lever

8061-228

Lengthways adjustment

22

Image 22

Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade Switch Throttle Control Choke Control Ignition SwitchFuses Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterSeat Adjustment Lever Always raise the deck to the highest position for transportTracking Knob Hour MeterBypass Linkages Training OperationSteering Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position Jumper Cables Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine by Hand Maintenance interval MaintenanceMaintenance Schedule Daily Least Hours Once Before AfterMaintenance Daily Once Hours Each Before After 100 300Battery Replacing batterySafety System Tire PressuresBelts Deck Belt RemovalBelt installation Pump Belt Replacing pump beltBlade replacement Cutting BladesAdjusting the Mower Deck Leveling deckHardware Caster WheelsAnti-Scalp Rollers Cleaning Use protective glasses when cleaning and washingLubrication GeneralFront Wheel Bearings Wheel and Deck ZerksFront Wheel Mount Deck SpindlesTransaxle Transmission Fluid Change Troubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications Standard HardwareEngine DimensionEZ4824T BF \ TransmissionConformity Certificates USA requirementsDelivery Service Action Date, mtr reading, stamp, signHour Service After the first 5-8 hoursService Journal At Least Once Each Year Page 115 505927 Rev B 2012-07-30