Husqvarna RZ4623/967009801 warranty Fuel Shut Off Valve, Cutting Height Adjuster, Bypass Linkages

Page 22

CONTROLS

Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of the seat. The valve is off when the handle tab is turned perpendicular to the fuel line.

IMPORTANT INFORMATION

Always raise the deck to the highest position for transport.

Cutting Height Adjuster

To set the desired deck cutting height, press the release button and move the lever forward to the preset height pin and release the button. See Before Starting in the Operation section to change the cutting height. The cutting height range is from 1½" (38mm) to 4" (102mm) in ½" (13mm) increments. The heights are measured from the ground up to the blade tip with the engine not running.

IMPORTANT INFORMATION

To obtain an even cutting height, it is important that the air pressure in all tires is 15 psi / 103 kPa / 1 bar.

Bypass Linkages

The levers are located on each side of the rear of the unit below the rear engine plate. The bypass linkage is used when manually pushing or pulling the unit.

See Moving Machine By Hand in the Operation section.

WARNING!

Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levers are handled.

8011-419

Fuel shut off valve in the CLOSED position

8058-206

The mower deck’s lifting lever

8058-0147

Left side bypass linkage

22

Image 22

Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Bypass Linkages Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportHour Meter Seat Adjustment LeverSeat should not be adjusted while unit is in motion Tracking KnobTraining OperationSteering Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position Jumper Cables Use Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Daily Maintenance interval Least Hours Once Each MaintenanceMaintenance Schedule Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersBelts Deck Belt InstallationDeck Belt Removal Blade replacement Cutting BladesAdjusting the Mower Deck Leveling deckUse protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationGeneral Front Wheel Mount Wheel and Deck ZerksTransmission Front Wheel BearingsProblem Cause TroubleshootingMaintenance Section Troubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications Standard HardwareEngine Dimensions967009801 TransmissionConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16