Husqvarna RZ4623/967009801 warranty Seat Adjustment Lever, Hour Meter, Tracking Knob

Page 23

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways. When making adjustments, the lever under the right side of the seat is pulled up, after which the seat can be moved backward or forward.

IMPORTANT INFORMATION

Seat should not be adjusted while unit is in motion.

8058-023

Lengthways adjustment

Hour Meter

The hour meter displays the total operating time.

It will flash CHG OIL (Change Oil) at 50 hour intervals. The flash duration is one hour before and one hour after the interval. The CHG OIL icon will come on and shut off automatically. The hour meter cannot be manually reset.

Tracking Knob

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (103 kPa / 1 bar) for all tires. Tracking must be checked on a flat and level concrete or blacktop surface.

Rotating the tracking knob allows fine tuning adjustments so the machine tracks straight with the steering control levers in the full forward position.

Rotate the knob counter clockwise (as viewed from the operation position) to increase the speed on the left lever. Rotate clockwise to decrease speed.

8058-173

Hour meter

8058-187

Tracking knob

23

Image 23

Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Performing any General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Spark Arrestor TransportControl Locations ControlsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Always raise the deck to the highest position for transport Cutting Height AdjusterFuel Shut Off Valve Bypass LinkagesTracking Knob Seat Adjustment LeverSeat should not be adjusted while unit is in motion Hour MeterSteering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Use Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Before After MaintenanceMaintenance Schedule Daily Maintenance interval Least Hours Once EachBefore After 100 300 Daily At least Maintenance Once Interval Each HoursReplacing battery BatterySafety System Anti-scalp Rollers Tire PressuresDeck Belt Removal Deck Belt InstallationBelts Cutting Blades Blade replacementLeveling deck Adjusting the Mower DeckCaster Wheels CleaningRemoval and installation of caster wheel Use protective glasses when cleaning and washingGeneral LubricationLubrication Schedule Front Wheel Bearings Wheel and Deck ZerksTransmission Front Wheel MountMaintenance Section TroubleshootingProblem Cause Troubleshooting Winter Storage ServiceStorage Schematics Standard Hardware Technical DataTorque Specifications AccessoriesTransmission Dimensions967009801 EngineUSA requirements Conformity CertificatesDelivery Service Service JournalAfter the First 10 Hours Hour ServicePerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16