Husqvarna RZ4623/967009801 warranty Moving Machine By Hand

Page 34

OPERATION

Moving Machine By Hand

When pushing or pulling the mower, engage the EZT bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard.

1.Raise the deck into the highest cutting position.

2.Engage the parking brake.

3.Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position.

4.To reengage the EZT’s to drive, reverse the above procedure.

Load the machine into truck or trailer by driving slowly up the ramps. DO NOT LIFT! The machine is not intended to be lifted by hand.

WARNING!

Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levers are handled.

WARNING!

Make no adjustments without:

the engine stopped,

the ignition key removed,

the parking brake activated

8058-032

Left side bypass linkage, EZT engaged

8058-033

Left side bypass linkage, EZT locked in the bypass position

WARNING!

Use extreme caution when loading the machine into a truck or trailer using ramps. There is the possibility of serious injury or death if the machine falls off the ramps.

34

Image 34
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Bypass Linkages Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportHour Meter Seat Adjustment LeverSeat should not be adjusted while unit is in motion Tracking KnobTraining OperationSteering Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position Jumper Cables Use Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Daily Maintenance interval Least Hours Once Each MaintenanceMaintenance Schedule Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersBelts Deck Belt InstallationDeck Belt Removal Blade replacement Cutting BladesAdjusting the Mower Deck Leveling deckUse protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationGeneral Front Wheel Mount Wheel and Deck ZerksTransmission Front Wheel BearingsProblem Cause TroubleshootingMaintenance Section Troubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications Standard HardwareEngine Dimensions967009801 TransmissionConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16