Husqvarna Complete RZ4623 Manual: Ignition Switch, Starter, and Fuse Information
Page 20

CONTROLS

Ignition Switch

The ignition switch is placed on the control panel and is used to start and stop the engine.

On models equipped with headlights, turn the key clockwise to ACCESSORY for headlight use.

8052-001

Ignition switch

Choke Control

The choke control is used for cold starts to provide the engine with a richer fuel mixture.

For cold starts throttle/choke control should be pushed fully forward forward to the choke position.

Fuses

Fuses are located on the left hand side of the machine. They are accessed by tilting the seat forward. They are flat pin fuses of the same type used in automobiles.

There are two fuses with ratings and functions:

20 Amp Primary fuse

7.5 Amp Mower deck coupling

8058-173

Choke control

8011-420

Fuses

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark Arrestor Controls Control LocationsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Cutting Height Adjuster Fuel Shut Off ValveBypass Linkages Always raise the deck to the highest position for transportSeat Adjustment Lever Seat should not be adjusted while unit is in motionHour Meter Tracking KnobSteering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Use Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Maintenance ScheduleDaily Maintenance interval Least Hours Once Each Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersDeck Belt Removal Deck Belt InstallationBelts Blade replacement Cutting BladesAdjusting the Mower Deck Leveling deckCleaning Removal and installation of caster wheelUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationLubrication Schedule Wheel and Deck Zerks TransmissionFront Wheel Mount Front Wheel BearingsMaintenance Section TroubleshootingProblem Cause Troubleshooting Winter Storage ServiceStorage Schematics Technical Data Torque SpecificationsAccessories Standard HardwareDimensions 967009801Engine TransmissionConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16
Top Page Image Contents