Husqvarna RZ4623/967009801 Weak Battery, Jumper Cables Use, To remove cables, reverse order

Page 29

OPERATION

Weak Battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles.

If the battery is too weak to start the engine, it should be recharged. (See Battery in the Maintenance section.)

Jumper Cables Use
1. Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking	8011-642
care not to short against chassis.	Jumper cable connection

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

3.Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

4.Remove BLACK cable first from chassis and then from the fully charged battery.

5.Remove RED cable last from both batteries.

29

Image 29

Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Performing any General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Spark Arrestor TransportControl Locations ControlsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterBypass Linkages Always raise the deck to the highest position for transportSeat should not be adjusted while unit is in motion Seat Adjustment LeverHour Meter Tracking KnobSteering OperationTraining Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Use Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Schedule MaintenanceDaily Maintenance interval Least Hours Once Each Before AfterBefore After 100 300 Daily At least Maintenance Once Interval Each HoursReplacing battery BatterySafety System Anti-scalp Rollers Tire PressuresDeck Belt Removal Deck Belt InstallationBelts Cutting Blades Blade replacementLeveling deck Adjusting the Mower DeckRemoval and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationLubrication Schedule Transmission Wheel and Deck ZerksFront Wheel Mount Front Wheel BearingsMaintenance Section TroubleshootingProblem Cause Troubleshooting Winter Storage ServiceStorage Schematics Torque Specifications Technical DataAccessories Standard Hardware967009801 DimensionsEngine TransmissionUSA requirements Conformity CertificatesDelivery Service Service JournalAfter the First 10 Hours Hour ServicePerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16