Husqvarna RZ4623/967009801 warranty Troubleshooting, Problem Cause, Maintenance Section

Page 46

TROUBLESHOOTING

Problem

Cause

 

 

 

Engine will not start

Blade switch is engaged.

 

• Steering controls are not locked in the neutral position

 

• Parking brake is not activated

 

Battery is dead

 

• Contamination in the carburetor or fuel line.

 

• Fuel supply is closed or the shutoff valve for the fuel tank is in

 

 

the wrong position

 

• Clogged fuel filter or fuel line

 

Ignition system faulty

 

 

 

Starter does not turn the engine over

Battery is dead

 

• Poor contact of the battery terminal cable connections

 

Blown fuse

 

• Fault in the starter safety circuit. See Safety System in the

 

 

Maintenance Section

 

 

 

Engine runs rough

Faulty carburetor

 

• Choke control is pulled out with a warm engine

 

• Clogged fuel filter or jet

 

• Clogged ventilation valve on the fuel cap

 

• Fuel tank nearly empty

 

Fouled spark plugs

 

• Rich fuel mixture or fuel-air mixture.

 

Wrong fuel type

 

Water in fuel

 

Clogged air filter

 

 

 

Engine seems weak

Clogged air filter

 

Fouled spark plugs

 

Carburetor incorrectly adjusted

 

• Air trapped in hydraulic system

 

 

 

Machine vibrates

Blades are loose

 

• Blades are incorrectly balanced

 

Engine is loose

46

Image 46
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Bypass Linkages Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportHour Meter Seat Adjustment LeverSeat should not be adjusted while unit is in motion Tracking KnobTraining OperationSteering Before Starting Starting the Engine Move the throttle to the middle position Press in and turn the ignition key to the start position Jumper Cables Use Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Daily Maintenance interval Least Hours Once Each MaintenanceMaintenance Schedule Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersBelts Deck Belt InstallationDeck Belt Removal Blade replacement Cutting BladesAdjusting the Mower Deck Leveling deck Use protective glasses when cleaning and washing Cleaning Removal and installation of caster wheel Caster WheelsLubrication Schedule LubricationGeneral Front Wheel Mount Wheel and Deck ZerksTransmission Front Wheel BearingsProblem Cause TroubleshootingMaintenance Section Troubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications Standard HardwareEngine Dimensions967009801 TransmissionConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Service Journal Page 115 457827 Rev B 2012-01-16