3Com 206380-A manual Enter the following syntax

Software Installation

4.Enter the following syntax:

B22ENA10 [/IRQ:x][/IOP:xxx] where:

•IRQ is the interrupt number used specifically for the BayStack 22 network card. This number must not be used by any other device in the system. The default IRQ value is 3.

•IOP is the starting input/output (I/O) port address, in hexidecimal format. The BayStack 22 network card requires 32 consecutive free I/O port addresses. The default IOP value is 0x300.

For example, the following command enables a BayStack 22 network card having an IRQ value of 5 and an IOP value of 300:

B22ENA10 /IRQ:5 /IOP:300

Note: If you installed the EMM386.EXE program in CONFIG. SYS, you must exclude the memory address range D000 to DFFF or D400 to D7FF in the EMM386.EXE program. The B22ENA10.EXE program uses this memory address range to read configuration information from the BayStack 22 network card.

For example, the following commands exclude the required memory address range:

DEVICE=EMM386.EXE NOEMS X=D400-D7FF

DEVICE=EMM386.EXE NOEMS X=D000-DFFF

5.Access the Novell NetWare client directory on your client laptop.

6.From the \NETWARE\DOSODI directory on the BayStack 22 PCMCIA Card Adapter Software & Documentation CD, copy the following files:

LSL.COM

B22ODI10.COM

IPXODI.COM

NETX.EXE

NET.CFG

The STARNET.BAT file in the \NETWARE\DOSODI directory executes the first four files automatically, in the correct sequence. Refer to “ Client Files” on page B-4 for descriptions of these files.

206380-A 3-37