3Com 206380-A manual INT Parameter, PORT Parameter, LOAD B22LAN10 FRAME=ETHERNET

Novell NetWare Reference Information

The following are examples of typical FRAME parameters:

LOAD B22LAN10 FRAME=ETHERNET_802.2

LOAD B22LAN10 FRAME=ETHERNET_802.3

LOAD B22LAN10 FRAME=ETHERNET_II

LOAD B22LAN10 FRAME=ETHERNET_SNAP

INT Parameter

The INT parameter refers to the interrupt (IRQ) value used by the BayStack 22 network card. The INT value must match the IRQ value you specify when enabling the B22ENA10 program. You must use a DOS prompt to enable this program before you access your Novell NetWare 4.x server. Refer to “ Installing the Network Card in a Novell NetWare Server” on page 3-32 for instructions.

The following is an example of a typical INT parameter:

LOAD B22LAN10 INT=3 FRAME=ETHERNET_802.2

PORT Parameter

The PORT parameter reflects the input/output (I/O) port address of the server. The PORT value must match the IOP value you specify when enabling the B22ENA10 program. You must use a DOS prompt to enable this program before you access your Novell NetWare 4.x server. Refer to “ Installing the Network Card in a Novell NetWare Server” on page 3-32 for instructions.

The following is an example of a typical PORT parameter:

LOAD B22LAN10 INT=3 PORT=300 FRAME=ETHERNET_802.2

206380-A B-3