12CHAPTER 1: GETTING STARTED

To install and charge the battery:

1Remove the rear cover on the handset (See Figure 1 on page page 16.)

2Insert the battery in the compartment so that the metal contacts on the battery and handset are aligned.

3Replace the rear cover of the handset.

4Plug the AC power adapter into the USB Data Cable slot on the bottom of the handset. (See Figure 2 on page page 17.)

5Plug the other end of the power adapter into the appropriate AC outlet.

WARNING: When you connect the country-specific power supply adapter, always connect the adapter to the power supply before you connect to the wall outlet.

For first time usage, you should charge the battery for at least 8 hours. While the phone is charging, you can still do phone operations according the instructions in this guide. The battery charging status is accurate only after uninterrupted charging/ discharging. The battery can get warm during charging. This is not a malfunction. If the battery is completely exhausted, you need to charge the battery for approximately three hours (with the phone powered off) to reach full capacity.

Powering the

You use the same key to power the phone on and off.

Phone On and Off

To power On the phone — press and hold the

Power key.

 

 

To power OFF the phone — press and hold the

Power key.

 

 

About

To minimize power consumption, the LCD display automatically goes dim

Power-Saving

after 15 seconds (default setting) without any operations. You can

Mode

change this setting to 30 Seconds or Always On. For details, see LCD

 

Off Time in the “Settings” menu described on page 49.

 

To reactivate the LCD display, press any key.

 

 

 

Care and

Note the following tips to keep your phone in proper operating

Maintenance

condition:

 

Keep your phone and accessories away from dusty, wet or dirty areas.

Page 12
Image 12
3Com 3C10408A manual Powering, Phone On and Off, About, Power-Saving, Mode, Care Maintenance