3Com 8807, 8814, 8810 manual Press Ctrl+B as prompted to display the system Password prompt

	Upgrading the Software 87
Board self testing
The board is steady
SlotNo of this board is 6
The MCX is exist
BootRom main system CRC check is OK
82559 register testing is OK
EPLD1 testing is OK
EPLD2 testing is OK
16c2552 register testing is OK
Please check LEDs	LED testing finished
The switch Mac address is 00e0.fc00.1111
Press Ctrl+B to enter Boot Menu...	5
Password :

1Press <Ctrl+B> as prompted to display the system Password : prompt.

n To enter the Boot menu, you must press <Ctrl+B> within five seconds after the appearance of the “Press Ctrl-B to enter Boot menu...” prompt. Otherwise, the program decompression process begins. To access the Boot menu after the switch enters the program decompression process, you need to restart the switch.

2Enter the Boot ROM password (the switch’s default is no password). The Boot menu displays as follows:

c CAUTION: Make sure you have Boot ROM password.

MAIN MENU

1.Boot with default mode

2.Boot from Flash

3.Boot from HardDisk

4.Enter serial submenu

5.Enter ethernet submenu

6.Modify Flash description area

7.Modify bootrom password

0. Reboot

Enter your choice(0-7):

3Ensure that the upgraded host program is compatible with the existing I/O module’s Boot ROM program. Otherwise, you must upgrade it during a host program upgrade.

4When loading the host program through the Boot menu, configure the serial interface’s attributes as shown in Figure 62. Otherwise, the Hyper Terminal does not respond.