3Com 8810, 8807, 8814 manual setting the baud rate and reconnect the terminal after it is complete

Upgrading the Software 89

2Type 4 in the serial interface submenu and press Enter to set the serial interface download parameters from the following menu:

1:9600(default)

2:19200

3:38400

4:57600

5:115200

please select an appropriate baudrate: Enter your choice(1-5): 5

3Select the download speed as needed. For example, enter 5 to select the download speed of 115200 bps, then press Enter. The system displays the following information:

BaudRate is 115200 bps. Please change the terminal’s speed to 115200

bps

4Change the baud rate on the Console terminal to match your specification, disconnect the terminal, connect it again, then press Enter. The terminal displays the serial interface submenu again:

SERIAL SUBMENU

1.Download file to SDRAM through serial interface and boot

2.Download file to Flash through serial interface

3.Download file to HardDisk through serial interface

4.Modify serial interface boot parameter

0.Return to main menu Enter your choice(0-4):2

n	■	After changing the baud rate, you must close the terminal emulation program
		and start it again at least once in order to validate the new baud rate.
	■	In Windows 98, you can disconnect and reconnect the terminal after changing
		the baud rate. In Windows 2000, you must disconnect the terminal before
		setting the baud rate and reconnect the terminal after it is complete.

5Choose where you wish to store the downloaded file. For example, enter 2 to download the file into the switch’s Flash memory then, press Enter. The system displays the following information as it is downloading the file:

Please Select File .

XMODEM downloading ...CCC

6Select [Transfer/Send File] in the terminal window. The Send File dialog box appears as shown in Figure 62.

7Click Browse, and select the application, and change the protocol to XModem.