2-4 CHAPTER 2: INSTALLING THE LINKBUILDER MSH
DUA1800-0AAA04
There are two sets of holes on each side of the MSH chassis.
These allow for fitting the mounting brackets to two different
positions:
■If you decide to have the face of the chassis that takes the cable
connections and shows module LEDs as the front, fit the brackets
to the holes near this face.
■If you decide to have the face of the chassis that is clear of
connections as the front, fit the brackets using the set of holes
towards the rear face.
If you decide on this configur ation, the display panel above the
module slots must be moved. Refer to The Display Panel on page
2-15.
1Match the appropriate bracket with the holes on the side face of
the MSH chassis.
2Locate the four slotted screws into the holes and tighten using a
flat-tipped screwdriver.
To remove the bracket, loosen the four screws, and lift it away.
Store both brackets and screws safely for future use.

Installation Into A 19 Inch Rack

1Fit the mounting brackets that are supplied with the chassis to the
face which you have decided is the front of the chassis.
2Refer to the manufacturer's documentation that accompanies the
19 inch rack for details of installation. If there is a door fitted to
the rack, it is essential that there is adequate clearance between
the door and the front of the MSH chassis to prevent dam age to
cables and connectors.
Chassis.bk : CHAPTER2 Page 4 Monday, February 10, 1997 1:11 PM