DUA1800-0AAA04
LinkBuilder ECS Modules 3-25
5Make sure that the converter is securely fitted to the module.
Engage the module into the slot, u sing just sufficient force to
ensure that the connector on the edge of the converter mates
with the socket on the MSH backplane.
6Locate the two round-headed screws supplied as part of the
module assembly, in the tapped holes at the top and bottom of
the module. Tighten the screws.
7Reposition the locking bar and tighten the two screws to secure it
in place.
Removing An ECS Module From The MSH Ch assis
1Remove all network connections from the module that will be
removed.
2Remove the locking bar from the front of the chassis.
3Remove the round-headed screws from the top and bottom of
the module. Carefully withdraw the module from the chassis. The
converter should come out with it ; if it does not, contact your
supplier for advice.
4If you do not intend to fit a replacement module immediately, you
must cover the vacant slot with a blanking plate. This prevents
dust from entering the chassis and helps the circulation of cooling
air. See Blanking Plates on page 3-16
5Reposition the locking bar and tighten the two screws to secure it
in place.
6If necessary remove the converter from the module.
Chassis.bk : CHAPTER3 Page 25 Monday, February 10, 1997 1:11 PM