DUA1800-0AAA04
Introduction 2-5

The Locking Bar

The MSH chassis is delivered with a locking bar fitted. Once the
MSH is fully assembled and insta lled, you must refit this locking
bar. This will prevent the removal and replacement of power
supplies, modules etc. by unqualified personnel.
Fitting The Locking Bar
1Position the locking bar so that its two captive, fixing screws
align with holes in the thermal management unit. Note that for
clarity, the captive screws are shown removed from the bar in
Figure 2-2.
2Locate two small screws into the appropriate holes and tighten
fully with a flat bladed screwdriver.
To remove the locking bar, loosen two screws and remove bar.
Figure 2-2 Installing the Locking Bar
Chassis.bk : CHAPTER2 Page 5 Monday, February 10, 1997 1:11 PM