3-20 CHAPTER 3: INSTALLING MODULES INTO THE MSH CHASSIS
DUA1800-0AAA04

Removing A Module

1Warn all users who are likely to be affected. Remove all network
connections from the module that you wish to remove.
2Remove the locking bar from the front of the chassis.
3To unlock the module ejector, press the sprung catch and move
the flap to the open position. See Figure 3-5. This operation must
be applied simultaneously to both ejectors on the module
.
Figure 3-5 Ejecting the module
4If a replacement module is not to be fitted i mmediately, the
vacant slot must be covered with a blanking plate.
5Reposition the locking bar and tighten the two screws to secure it
in place.
Chassis.bk : CHAPTER3 Page 20 Monday, February 10, 1997 1:11 PM