Before You Install Software 2-5
Figure 2-3 NIC LEDs at Power Up
Before You Install Software
Before you install a software driver, you may want to run
the Configuration and Diagnostic Program, as described in
Chapter 4.
See the instructions in Chapter 3 to install the driver from
the 3Com diskette. For information on LED states after the
software is installed, see Table 4-1 in Chapter 4.
Be sure that the NIC hardware and software are installed
correctly before replacing the computer cover.
TX
TX
ACT
10
100
L
N
K
ACT: Off until the network driver is installed;
after driver installation, yellow indicates port traffic
10 LNK:
100 LNK:Green indicates 10 Mbps link integrity
Green indicates 100 Mbps link integrity
ACT
10 LNK
100 LNK