Hardware Installation and Configuration
•If the rack comes with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
•If the rack is partially filled, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.
•If you plan to expand your system to include additional TippingPoint
Connect the power
STEP 1
STEP 2
STEP 3
Locate the male power inlet on the back of the chassis.
Plug one end of a standard female power plug into the power inlet
Plug the other end into an AC outlet or power strip and press the power switch to power on.
CAUTION: The X505 may take several minutes to boot up. When the Status LED is steady green, the device is powered up and ready to use.
Complete Initial Setup Configuration
STEP 1
STEP 2
STEP 3
STEP 4
Configure your computer’s network connection to receive an IP address by DHCP.
Use an Ethernet cable to connect your computer to the X505 LAN port. Your computer will receive an IP address from the X505 device.
With your computer’s internet browser, connect to the X505 default LAN address (https:// 192.168.1.254).
The OBE wizard opens.
STEP A
STEP B
STEP C
Accept the default security level of Level 2.
Specify the SuperUser account information at the prompt:
•User Name
•Password
•Confirm password
Accept the default settings in the rest of the Setup Wizard by clicking No when prompted.
STEP D Depending on your internet connectivity, you may need to update your WAN set- tings in the Virtual Interfaces setup screen.
•If you use DHCP to connect to your Internet provider, accept the default WAN settings.
•If you use PPPoE, enter your ISP user name and password.
•If your ISP assigns a static IP address, select Static as the external interface type and enter the IP address, subnet mask, and default gateway information.
21
