Software Installati on Procedure 23
Example Host IP address [192.9.200.14]: 192.9. 200.96
Install file pathname[/usr/c b2 500/lp2500c]:
User name: scottco
Password:
Programming flash memor y block 1 of 15...
Programming flash memor y block 2 of 15...
Programming flash memor y block 3 of 15...
.
.
Programming flash memor y block 15 of 15...
Installation complete.
6Proceed to “Rebooting the System” next.
Rebooting the System
To reboot your system, follow these steps:
1From the top level of the Administration Conso le, enter:
system reboot
2When the reboot is complete, log in to the system and proceed to
“Reloading the Compressed Image” next.
Reloading the Compressed Image
You must load the compresed image file again. Follow these steps:
1From the top level of the Administration Conso le, enter:
system softwareUpdate
The system prompts you for several items of information.
Press Return at any prompt to accept the defaul t value that is shown in
brackets.
2At the Host IP address prompt, enter the IP address of the host
device from which y ou are retrieving the c ompressed image.
3At the Install file pathname prompt, enter the complete pat h
and filename.
Paths and filenames are case-sensitive. Be sure to type them exactly as
shown on the hard disk of the host device.
For an MS-DOS host, you must precede the full path with a forward
slash (/). Example: /c:\3com\cb2500\lp2500c
4At the User name prompt, enter your user name.