3M 40800 Operation, Operators Correct Working Position and, Starting Production, Figure, Hand

12-OPERATION

12.1 Operator's Correct Working Position and					12.3 Starting Production
		Operational Flow (Figure 12-1).			After having adjusted the machine according to the
					box dimensions (height-width), let the machine run
					without cartons and check its safety devices. Then
					start the working cycle.
					12.4 Tape Replacement and Threading
					Skill 1 - Operator
					See Manual 2: AccuGlide™ 3 High Speed 3 inch
		Figure 12-1			Taping Heads.
Once the box has been filled, close its top flaps and					Press the
push it between the top and bottom drive belts.					LATCHING EMERGENCY STOP BUTTON.
Always keep hands in position as shown in
Figure 12-2.							WARNING
The box will be automatically sealed with adhesive
tape on the top and bottom box seams. Then the						• To reduce the risk associated
box will be expelled on the exit conveyor.						with sharp blade hazards:
						− Keep hands and fingers away from tape
			Hand
						cutoff blades under orange blade guards.
			Position			The blades are extremely sharp.
					12.5 Box Size Adjustment
					Repeat all the operations shown in
					Section 11 - Set-Up and Adjustments.
					12.6 Cleaning
					Before carrying out any cleaning or maintenance
	Figure 12-2
					operation stop the machine by Pushing the OFF (O)
					switch on the main and disconnect the electric power
12.2 Starting the Machine
					(Figure 12-3).
Important: Before starting the machine, verify that
	no tools or other objects are on the conveyor bed.				12.7 Table of Operation Adjustments -
Push the main switch ON (I) after the EMERGENCY
						Operator Qualifications
BUTTON is released (Figure 12-3).
				1		Tape loading and threading		1
				2		Tape web alignment		1
				3		Adjustment of one way tension roller		1
				4		Adjustment to box size (H and W)		1
				5		Top flap compression rollers		1
				6		Adjustment of tape applying spring		1
				7		Conveyor bed height adjustment		1
				8		Special Adjustment-Changing tape leg length		2
				9		Special Adjustment-Column re-positioning		2
					12.8 Safety Devices Inspection
				1		Taping units blade guard
				2		Latching emergency stop button
				3		STOP (OFF) (O) main switch
		Figure 12-3
							2011 October
	700aks-NA			27