11 - SET UP AND ADJUSTMENTS (continued)
Figure
11.5 Special
Figure
Figure
Moving the outer columns up one set of mounting holes increases the maximum box height handled by the 700aks case sealer and decreases the minimum conveyor bed height.
1- Place solid blocks approximately 305mm high at the front and rear of the upper taping head assembly as shown in Figure
2- Crank the upper taping head assembly down until it touches these blocks.
3- Remove and retain the six (6) screws and plain washers that fasten each column to the frame (Figure
4- Turn the height adjustment crank clockwise to raise the outer columns up one set of mounting holes.
5- Install and tighten the six screws and plain washers in each column. Crank upper taping head assembly up and remove blocks.
AB
305mm
Minimum
Figure
25 | 2011 October | |
|
|