3M 800a3 manual Specifications Tape Roll Diameter, Tape Application Leg Length Standard, Box Board

4-SPECIFICATIONS (continued)

Specifications

6.Tape Roll Diameter

Up to 405mm [16 inch] maximum on a 76.2mm [3 inch] diameter core. (Accommodates all system roll lengths of Scotch® film tapes.)

7.Tape Application Leg Length – Standard

70 mm ± 6mm [2.75 inch ±. 25 inch ]

Tape Application Leg Length – Optional

50 mm ± 6mm [2 inch ±. 25 inch]

(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")

8.Box Board

Style – regular slotted containers – RSC

125 to 275 P.S.I. bursting test, single wall or double wall B or C flute.

23-44 lbs. per inch of width Edge Crush Test (ECT)

9.Box Weight and Size Capacities

A. Box Weight, filled: 5 lbs.–85 lbs. [2.3 kg–38.6 kg]. Contents must support flaps.

B. Box Size:		Minimum		Maximum
Length –		150mm [6.0 inch]		Unlimited
Width	–	140mm	[5.5 inch]*	545mm	[21.5 inch]
Height	–	120mm	[4.75 inch]** ***	620mm	[24.5 inch] ***

*Minimum box height can be reduced to 110mm [4-1/4 inches] by removing machine compression rollers OR Minimum box height can be reduced to 90mm [3 1/2 inches] by removing machine compression rollers and also adjusting taping heads to apply 48mm [2 inch] tape legs (See "Special Set-Up Procedure".)

**Maximum box height can be increased to7 25mm [28-1/2 inches] by relocating machine outer columns to upper position. (See "Special Set-Up Procedure".)

Note: Raising columns to upper position also increases minimum box height to 210mm [8-1/4 inches].

Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box length (in direction of seal) to box height ratio is 0.6 or less, test run several boxes to ensure proper machine performance.

DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:

BOX LENGTH IN DIRECTION OF SEAL	= SHOULD BE GREATER THAN 0.6
BOX HEIGHT

Any box ratio approaching this limitation should be test run to ensure performance.

800a3-NA	2011 September
	13