3M 800a3 manual INSTALLATION continued

7-INSTALLATION (continued)

7.5 Removal of Plastic Ties

Cut the plastic which attaches the top head to the frame and remove the polystyrene blocks (Figure 7-4).

Figure 7-4

Cut the plastic strap which attaches the strip and the EMERGENCY STOP cable to the frame (Figure 7-5).

Figure 7-5

Cut the plastic ties holding the lower taping head in position (Figure 7-6).

Figure 7-6

7.6 Assembly Completion

1Crank - Install the crank handle on the top of the left column as shown (Figure 7-7A).

2Tape Drum Bracket - Install the upper tape drum bracket on the top cross bar as shown

(Figure 7-7B).

3Stop Bracket - Raise upper head assembly (turn crank handle counterclockwise) and install the two stop brackets (provided in the parts bag). Use lower set of holes as shown in Figure 7-7D.The upper set of holes should only beused when both taping heads are adjusted to apply 50mm tape legs.

B

A

		C
		D
Figure 7-7
800a3-NA		2011 September
		18