Chapter 2: Installing the monitor
3.Follow the screen prompts to install the driver and then follow the on- screen instructions of the Setup Wizard.
Note: When the Baseline dialog box appears, select Skip. When the Linearization Data Download dialog box appears, select Skip. Baseline and linearization data are built into the monitor at the factory.
4.When the Setup Wizard finishes, an Install Successful window appears.
Installing the drivers for Windows NT 4.0 and Windows 9X operating systems
To install the touch screen software for Windows NT 4.0 and Windows 9X operating systems, follow these steps:
1.Find the floppy disk that includes the drivers for Windows NT 4.0 and Windows 9X operating systems, insert it in the disk drive, and browse the floppy disk to find the file named install.exe.
2.Open install.exe.
The installation Welcome window appears.
3.Choose to install the driver and then follow the
When the software is installed, you will be prompted to restart.
Important
For Windows 98 operating system only: Turn off the Advanced Configuration and Power Interface (ACPI). If the Windows 98 operating system ACPI feature is not turned off, the COM port may not be accessible after
4.For Windows 98 operating system only, turn off the Advanced Configuration and Power Interface (ACPI). Follows these steps:
a.From the Windows operating system Start menu, select Settings, then select Control Panel, and then open System.
b.Click the Device Manager tab, then open System Devices, and then
c.Click the Driver tab, then click Update Driver, and then click Next.
d.Click Display a list of all the drivers, then click Next, and then click Show all hardware. A dialog box appears.
e.From the Manufacturers options (on the left side of the dialog box), select Standard System Devices and from the Models options (on the right), select PCI Bus, and then select Next.
23