8e6 Technologies TAR 1.0 Congure Network Interface screen

8e6 ThreaT analysis reporTer Quick sTarT Guide 21

Congure Network Interface screen

A. At the Enter interface LAN1 (eth0) IP address eld, enter the IP address for the

LAN 1 (Ethernet 0) interface, and then press Enter to go to the next screen.

B. At the Enter interface LAN1 (eth0) netmask eld, enter the subnet mask for the

LAN 1 (Ethernet 0) interface using the dotted decimals notation format. Press Enter

to display the conrmation prompt.

Contents

Main GUIDE 8e6 ThreaT analysis reporTer Quick sTarT Guide C threat analysis reporter introduCtion ....................................................1 appendix: optional ethernet tap installation ........................................46 Page threat analysis reporter introduCtion About this Document Conventions Used in this Document serviCe information 8e6 Corporate Headquarters (USA) 8e6 Taiwan Procedures preliminary setup proCedures Unpack the Unit from the Carton Rack Mount the S or MSA Server Rack Mount Instructions Rack Setup Suggestions Identify the Sections of the Rack Rails Install the Chassis Rails Install the Rack Rails Install the Server into the Rack Installing the Server into a Telco Rack Install the H Server Bezel Page Page Rack Mount the H Server Rack Mount Instructions Identify the Sections of the Rack Rails Install the Inner Rails Install the Outer Rails Install the Server into the Rack Installing the Server into a Telco Rack install the server Step 1: Initial Setup Procedures Link the Workstation to the Threat Analysis Reporter Monitor and Keyboard Setup Serial Console Setup HyperTerminal Setup Procedures Page Page Step-by-Step Initial Setup Procedures Login screen, password prompts Page Congure Network Interface screen Page Page Congure Host Name screen Time zone regional conguration screen Congure Wizard user screen Setup Wizard Conrmation screen Administration menu System Status Screen Log Off, Disconnect the Peripherals Step 2: Physically Connect the Unit to the Network Bandwidth Management Step 3: Wizard Setup Procedures Access the Threat Analysis Reporter Administrator Console Log in to the Threat Analysis Reporter Administrator Console Step 1: Register administrator Page Page Step 2: Register R3000 & ER R3000: Page ER: Page Step 3: Register Gauges Specify Gauge Groups to be Monitored View, Edit Gauge Components Step 4: Server Settings C s Physical Specications Specication S Value H Value MSA Value Internal Product Specications Specication S Value H Value MSA Value CPU Hardware Component Specications S and MSA Front Panel LED Indicators, Buttons Diagrams and Descriptions On S and MSA units, LED indicators and buttons display on the front panel to the right: E D C B A appendix: optional ethernet tap installation Preliminary Setup Procedures Unpack the Ethernet Tap Unit from the Box Other Required Installation Items Install the Ethernet Tap Unit Page Tap insTallaTion