A&D MC-10K One-Touch Calibration, Calibration using the internal mass, About the internal mass

8-3. One-Touch Calibration

Calibration using the internal mass

This function calibrates the balance using the internal mass. The only operation required is

to press the

CAL

key.

Step 1 Connect the AC adapter and warm up the balance for at least 30 minutes with nothing on the weighing pan.

Step 2 Press the

CAL

key.

Step	3	The balance displays	Calin		and performs calibration using the internal mass. Do
		not allow vibration or	drafts to		affect the balance.
Step	4	The balance displays		after calibration. If the "GLP output (info)" parameter of
			end
		the function table is set to "1" or "2", the balance displays					and outputs the
						glp
		"calibration report" using the RS-232C interface or stores				the data in memory. Refer
		to "11-2. GLP Report" and "Data memory (data)" of the function table for details.
Step	5	The balance will automatically return to the weighing mode after calibration.

About the internal mass

The value of the internal mass may change due to aging, corrosion or other damage caused by the operating environment. Check the internal mass periodically. Correct the internal mass value as necessary. Refer to "8-6. Correcting the Internal Mass Value".

To maintain the weighing accuracy, perform the calibration using an external weight periodically, as described below.

20