gis
11 Main menu
11.1 Introduction
The MENU is reached by pressing the 
button on the electronic controller.
MENU »OFF ^ ON
ÈWEEK PROGRAM
EXTRA PERIOD SETTINGS
The main menu comprises:
•OFF
Select this option if you wish to turn
off (10 "Shutting down") the appliance for a brief period, but do not wish to drain it. In this mode, the frost protection is active. This prevents water from freezing in the appliance.
•ON
In this mode, the appliance continually responds to the hot water demand. (11.3 "Switching on the "ON mode"")
•WEEK PROGRAM
Select this option to allow the appliance to respond to demand only during
For example, LANGUAGE is a submenu of SETTINGS. So, for example, to select the LANGUAGE menu, this manual uses the following notational convention:
•
: SETTINGS LANGUAGE
Confirm with 
.
This means:
1.
: Activate the main menu with 
.
2.SETTINGS: Use the 
and/or 
buttons to go to
SETTINGS and confirm with 
.
3.LANGUAGE: Use the 
and/or 
buttons to go to
LANGUAGE
4.Confirm with 
. After entering 
, you will have activated the LANGUAGE submenu.
11.3 Switching on the "ON mode"
You can switch the appliance to the ON mode from any operational mode, as follows:
1.
: ON START OPERATION
Confirm with 
.
Note
First consult the chapter about switching on (9 "Starting and running") too.
•EXTRA PERIOD
Select this option to overrule the OFF mode or PROG mode (i.e. Week program) so that a single temporary period (11.10 "Extra period") of heat demand will be fulfilled.
•SETTINGS
Select this option to set (11.12 "Settings") the language and the time. You can also use this option to display the regulation interval (temperature), and the ignition and working speeds of the fan.
Note
If you fail to make any selection with the main menu open, then after 30 seconds, the appliance will automatically return to the mode it was previously in.
11.4 Setting the water temperature
11.4.1Setting the water temperature via the SET POINT MENU
The water temperature can be set to any value between 40°C and 80°C.
Set the water temperature via:
1.
: ON CHANGE SETPOINT
Confirm with 
.
START OPERATION ^»CHANGE SETPOINT
ÈTset=65ÉC
2.Use:
11.2Notational convention for menu-related instructions
The MENU (
) of the electronic controller is divided into submenus. For example, SETTINGS is one of the functions reached from the main menu. The SETTINGS menu is divided into submenus in turn.
•
to increase the value;
•
to decrease the value.
Instruction manual BFC | 59 |
