Shutting down the projector
The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the pro- jector. The image returns when an active source is detected or a remote or keypad button is pressed.
Screen Save Time
You can make the black screen appear after a preset number of minutes by turning on the Screen Save Time feature in the Setup menu. See page 30.
Auto Off Time
The projector also has a Auto Off Time feature that automatically turns the lamp off after no active sources are detected and no user interaction with the projector is performed for 30 minutes. By default, this feature is off. You can change the length of time, see page 30.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp turns off and the LED blinks amber for 1 minute while the fans continue to run to cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does not, troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector and can help you troubleshoot.
Table 2: Status indicator light behavior and meaning
Status Indicator Panel icons | Meaning | |
|
| |
Power, solid amber | The projector is plugged in. | |
Power, blinking green | The power button has been pressed and | |
the software is initializing. | ||
| ||
Power, solid green | The projector is on and initialized. | |
| ||
Power, blinking amber | The power button has been pressed to | |
turn the projector off and the fans are | ||
| ||
| running to cool the projector. | |
|
| |
Thermometer | The projector is too hot. Make sure the | |
| vents aren’t blocked (see page 20). Turn | |
| off the projector and wait one minute, | |
| then turn the projector on again. Contact | |
| Technical Support if the problem persists. | |
|
| |
Lamp | Turn off the projector and wait one | |
| minute, then turn the projector on again. | |
| If the lamp light turns on again, replace the | |
| lamp and reset the lamp timer. | |
|
| |
Wrench/Service | Turn off the projector and wait one | |
| minute, then turn the projector on again. | |
| If the service lamp turns on again, service | |
| is required. Visit www.infocus.com/service | |
| to contact Service. | |
|
|
14
