GBC | Operation Manual |
FEATURES GUIDE
Refer to the following pages for detailed information on the above Features
FEATURES GUIDE (DETAILED DESCRIPTION)
FIGURE 1EMERGENCY STOP BUTTONS:
(Fig. 1– Item A)
A
FIGURE 2
FIGURE 3
Four Emergency Stops buttons are available on the Laminator on the top four corners of the Laminator.
To engage Emergency
To disengage turn the push button clockwise after the emergency condition has been resolved
Front Media Table:
The Media Table (Fig.2A) is used to position items for Lamination. There are two media tables on the machine one on the front & one on the rear of the Laminator. The Front Media table incorporates an Idler on the leading edge of the table.
Infeed Idler:
The Infeed Idler (Fig.2C) is used for roll to roll applications during lamination.
Pressure Plate:
The Pressure Plate (Fig. 2B) helps to keep images flat and assists when feeding images.
Safety Interlock Switch:
On both the Front Media & Rear Media tables, the Safety Interlock Switch (Fig.3A) will not allow the Laminator to operate at full speed unless the tables are properly installed.
Pressure Plate Release Lever:
The Pressure Plate Release Lever (Fig.3B) will allow the operator to remove the Pressure plate by pulling the lever out, releasing the locking pin, and remove the Pressure Plate.
Note:
The Laminator will operate only when the Media Table and Media Table Latch are Properly Installed
© 2009 General Binding Corporation an ACCO Brands CO. | Page 10 |