GBC
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Operation Manual
Rear Media Table:
The Rear Media Table (Fig.4A) is used to position items for Lamination. There are two media tables on the machine one on the front & one on the rear of the Laminator.
Table Safety Interlock Switch:
The Table Safety Interlock Switch (Fig.4B) ensures that the table is properly placed and secure. The Safety Interlock Switch will not allow the Laminator to operate at full speed unless the tables are properly installed.
Optical Safety System:
The Optical Safety System (Fig. 5A&6A) utilizes 2 optical beams located at the Main Roll Nip as well as the Pull Roll Nip. Once the Optical Eye is blocked, the machine will instantly stop unless the operator is using the Foot Switch. While using the Foot Switch and the Optical Eye is blocked, the machine will only operate at a fixed speed of 3ft/mn. Please refer to the Sequence of Operation.
Main Rollers:
The 2 Main Rollers (Fig.5 B&C) are used to apply Heat and Pressure to films being used. Silicone rubber coated steel tubes heat the laminating film and compresses the heated film to the items being laminated. Heat is provided by an internal heating element.
Pull Rollers:
The Pull Rollers (Fig.6 B&C) located at the back of the laminator are motor driven and the lower roller is clutched. They simultaneously pull the film and image.
Rewind Tubes:
The Rewind Tubes (Fig.7A) are used to rewind release liners or finished Medias.
Upper Tension Idler: (Fig.7B)
The Upper Tension Idler Guides the upper lamination onto the Top Main Roller insuring a constant amount of wrap on the Top Main Roller.
© 2009 General Binding Corporation an ACCO Brands CO. | Page 11 |
