ACCO Brands GBC 2064WF-1 operation manual Operating Instructions, Film Loading & Threading

GBC 2064WF-1 Operation Manual

OPERATING INSTRUCTIONS

Film Loading & Threading

The top and bottom rolls of laminating film must be of the same width and be present simultaneously. A Small amount of adhesive will “squeeze out” during Lamination. Hardened adhesive deposits can damage the heat rollers.

CAUTION:

Adhesive will deposit on the rollers if:

•Only one roll is used.

•Different widths of rolls are loaded together.

•Either roll is loaded adhesive side against a heat roller.

•One or both rolls of film are allowed to run completely off its core.

The adhesive side of the film is on the inner side of the web (Fig. 17A & B). The shiny side of clear film must contact the heat rollers. The dull side of the film contains the adhesive. Use extreme caution when loading delustered (matte) film as both sides appear dull.

Always change the top and bottom supply rolls at the same time. Near the end of each roll of GBC laminating film is a label stating “Warning-End of Roll”. The appearance of this label on either the top or bottom roll requires that new rolls of film be installed as soon as the item presently being laminated completely exits the rear of the laminator.

Do not introduce any additional items into the laminator when the warning label is visible.

		in
		-
	ly
o
P
											e
										iv
								s
						e
					h
				d						ce
				A
								fa
							r
					u
				s
											Polyester surface
				t
			u
		-o
	ly
o
P
											ive
										s
								e
						h
					d						ce
				A
										fa
									r
							u
					s
											Polyester surface

FIGURE 17

To load a roll of film: (Fig. 18)

1.Pull the swing out shaft clevis pin up.

2.Swing shaft outward.

3.Slide the roll of film onto the film shaft ensuring Adhesive side is out.

4.Push the film shaft back into the film shaft Support saddle.

5.Push the clevis pin down.

6.Center the roll of film.

1
		4
	2	5
		6
3		=

FIGURE 18

© 2009 General Binding Corporation an ACCO Brands CO. Page 17