ACCO Brands GBC 2064WF-1 Tips for Pre Coating Boards, Tips for Mounting Pre Coated Boards

GBC 2064WF-1 Operation Manual

APPLICATIONS

MOUNT

ADHESIVE

TRAILOR BOARD	LEADER BOARD
	BOARDS

FIGURE 30

IMAGE

RELEASE LINER

PRE-COATED BOARD

FIGURE 31

Tips for Pre Coating Boards

1.Load the laminator as illustrated in (Fig. 30). Remove chill idler.

2.The width of the roll should not exceed the width of the board by more than 1/2 in. (1.3 cm).

3.Use a leader board to set the main roller and pull roller pressure prior to webbing.

4.Use a leader board to start the run and a trailer board to finish the run.

5.Using the pull rollers will allow you to leave gaps between boards.

6.If not using the pull rollers, have the boards nearby to butt end to end during feeding.

Tips for Mounting Pre Coated Boards

1.Use a leader board to set the main roller pressure prior to mounting the image.

2.Ensure the chill idler is removed and the rear slitter is to one side.

3.Do not stop once you have started the mounting process through the machine. (Fig. 31)

Note: This application can also be performed from the rear operating position. Reference Fig. 34 for Illustration.

Tips for Single Sided lamination

RELEASE LINER FROM PSA FILM

IMAGE

KRAFT

PAPER

OPTION

MOUNT

ADHESIVE

OUTPUT

ROLL TO ROLL OPTION

1.	Load the laminator as illustrated in Fig. 32.
2.	Use kraft paper for one-sided lamination When
	ever the items to be laminated are narrower than
	the film you are using.
3.	If not using kraft paper, use a scrap piece to
	finish the run or you will have adhesive on your
	rollers.
4.	For high volume runs, use Kraft paper and the
	lower rear rewind for roll to roll operation.
5.	Running the web over the chill idler may
	improve the Flatness of the output.
6.	A little heat,125 degree F (52 degree C),may
	help eliminate silvering effects associated with
	PSA films.

FIGURE 32

© 2009 General Binding Corporation an ACCO Brands CO. Page 23