ACCO Brands GBC 2064WF-1 Main Power Cord A, Foot Switch B, Pull Roll Clutch Adjustment Knob A

GBC 2064WF-1 Operation Manual

FIGURE 15

A

B

FIGURE 16

Main Power Cord: (Fig. 15A)

The Main Power Cord Plugs into the Main Power Supply. See Power Requirements in the Specs part of the manual for required Voltage and Amperage.

Foot Switch: (Fig.15B)

The Foot Switch allows the operator to run the machine hands free. When the PICO System is not blocked, the Foot Switch will activate the Main Rollers, and the machine will run at the set speed on the Main Control Panel. The Speed can be adjusted by selecting the Speed button and using the Main Dial to increase or decrease speed while unit is running.

Pull Roll Clutch Adjustment Knob: (Fig. 16A)

The Pull Roll Clutch provides tension on the laminated film between the main rolls and pull rolls as the material is cooling.

FIGURE 17	IR Sensor:
	The IR Sensor (Fig. 16A) reads the temperature of
	the Rollers. The Top IR Sensor is shown in Fig.
	17. The Lower IR Sensor is located under the
	Lower Heat Roller and reads the temperature of
	the Lower Heat Roller

© 2009 General Binding Corporation an ACCO Brands CO. Page 14