￿The Driver and Documentation CD, which contains these items:

–The MegaRAID Configuration Software Guide

–The MegaRAID Operating System Driver Installation Guide

–The MegaRAID SCSI 320-0 ZCR Hardware Guide

–The software license agreement

–The MegaRAID SCSI 320-0 configuration utilities for DOS

￿The warranty registration card

6.2.2Step 2: Power Down

Turn off the computer, remove the power cord, then remove the cover. Make sure the computer is turned off and disconnected from any networks before installing the controller card.

6.2.3Step 3: Set Jumpers

Make sure the jumper settings on the MegaRAID SCSI 320-0 card are correct. The jumpers are set at the factory and you probably do not need to change them. Table 6.2 lists the jumpers (and a connector).

Table 6.2

Jumpers for the MegaRAID SCSI 320-0

 

 

 

Item

Description

Type

 

 

 

J2

Dirty cache LED

2-pin header

 

 

 

J3

Clear EPROM

2-pin header

 

 

 

J4

BIOS enable

2-pin header

 

 

 

J8

BBU daughter card connector

40-pin connector

 

 

 

Figure 6.1 shows the location of these items on the MegaRAID SCSI 320-0 controller.

Installation Steps

6-3

Copyright © 2002 by LSI Logic Corporation. All rights reserved.