Acnodes PCH 5120 3.8 POWER CONNECTION, 3.9 DRIVER INSTALLATION NOTE:

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909. 597.1939

are sub ject to c hange without not ice. For latest product in formation,

please visit Acnode s’ we b si te a t ww w.acnodes. com.

PCH 5120

12.1” industrial Panel PC

IP67 rated fully enclosure

Step 3: Secure the connector. Secure the serial device connector to the external inter-face by tightening the two retention screws on either side of the connector.3.7.4 USB DEVICE CABLE

To connect USB devices, please follow the instructions below.

Step 1: Located the USB connectors. The locations of the USB connectors are shown in Chapter 2.

Step 2: Align the connectors. Align the USB device connector with one of the connectors on the bottom

panel. See Figure 3-15.

Step 3: Insert the device connector. Once aligned, gently insert the USB device connector into the onboard

connector.

3.8 POWER CONNECTION

The power supply connects to the PCH5120 with an M12 connector.

Step 1: Connect the M12 connector to the PCH5120.

Step 2: Connect the power plug end to the mains power.

3.9 DRIVER INSTALLATIONNOTE:

The contents of the CD may vary throughout the life cycle of the product and is subject to change without

prior notice. Visit the IEI website or contact technical support for the latest updates.

The following drivers can be installed on the system, each driver is in its own directory on the driver CD:

ƒ Chipset driver

ƒ Graphics driver

ƒ LAN driver

ƒ Audio driver

ƒ Touch panel driver

ƒ Keypad utility driver

ƒ Wireless LAN card driver