14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909. 597.1939
© Copyright 2011 Acnodes, Inc.
All r ights reserv ed. Product descr iption and produ ct specific ations
are sub ject to c hange without not ice. For latest product in formation,
please visit Acnode s’ we b si te a t ww w.acnodes. com.
PCH 5120
12.1” industrial Panel PC
IP67 rated fully enclosure
NOTE:
A jumper is a metal bridge that is used to close an electrical circuit. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To CLOSE/
SHORT a jumper means connecting the pins of the jumper with the
plastic clip and to OPEN a jumper means removing the plastic clip from a
jumper.
3.4.1 RESET CMOSJumper Label: JP11
Jumper Type:3-pin header
Jumper Settings: See Table 3-1
This jumper will reset the CMOS. Turn off the system. Set the jumper to "Reset CMOS", turn on the power
for a few seconds. Turn off the system. Set the jumper back to "Normal".
3.4.2 AT/ATX POWERJumper Label: JP10
Jumper Type:2-pin header
Jumper Settings: See Table 3-2