Chapter 5 Setting Up Static IP

12.The “Save and Restart” page appears. Click “Save and Restart” to save the set- tings changed in the Change Admin Password screen.

The Gateway has been configured to support a single static IP address. Once the Power light stops blinking, the Gateway is ready for use.

Configuring for a Block of Static IP Addresses

To set up the Gateway to use a block of static IP addresses:

Note: To complete this procedure, you must have access to the Internet Service Provider (ISP) worksheet. If no worksheet has been provided, contact the ISP.

1.Open the Web browser. In the address bar enter: http://192.168.0.1

then press Enter on the keyboard.

2.The “Main Menu” screen appears. Select Setup/Configuration.

51

Page 54
Image 54
Actiontec electronic GT701-WG user manual Configuring for a Block of Static IP Addresses