Actiontec electronic GT701-WG - page 65

62

Actiontec 54 Mbps Wireless DSL Gateway User Manual

63

Chapter 6 Advanced Setup

Encapsulation

If the Gateway is configured to obtain an IP address through DHCP or to specify a

static IP address, select the appropriate encapsulation option used by the ISP (RFC

1483 Bridged or RFC 1483 Routed).

☞ Note: Contact the ISP if unsure of the proper configuration.

Unnumbered Mode/VIP Mode

If a block of public static IP addresses was purchased from the ISP, select

Unnumbered Mode by clicking in the appropriate check box. Then, enter the IP

Address and Subnet Mask in the “Gateway Address” and “Unnumbered Subnet

Mask” text boxes below the “Unnumbered IP Address.” Click Next, then click Save

and Restart to make all changes permanent.

The Unnumbered Mode feature automatically configures the appropriate IP rout-

ing for the IP Address block. The IP route will bypass NAT, enabling the public IPs

to be routed WAN-to-LAN, as well as LAN-to-WAN.

☞ Note: The IP Address information should be obtained from the

ISP when purchasing a block of public static IP address. Contact

the ISP if this information was not received.

Contents

Main Table of Contents 1 Introduction 1 2 Setting Up the Gateway 9 3 Using Qwest DSL 41 4 Basic Setup 43 Page Introduction Package Contents Minimum System Requirements Features Page Page N Technical Support Page Page Page Setting Up the Gateway Attention! Connecting a Computer to the Gateway Note: The following procedures are for U.S. installations only. Note: If I purchased my modem from Qwest was selected in Page Page Page Page Note: An Ethernet port looks similar to a phone jack, but is Page Page Page Note: If I purchased my modem from Qwest was selected in Page Page Page Page Page Page Installing Phone Filters M Caution: Do not unplug the green DSL cable from the phone M Caution: Do not plug a phone filter in the phone jack in which Page Note: You may have already unplugged this phone cord. M Caution: Do not unplug the green DSL cable from the phone Page Page Page Setting Up the DSL Connection Page Page Page Page Page Page Using Qwest DSL Connecting to the Internet Disconnecting from the Internet Page Basic Setup Basic Setup Page Page Page Setting Up Static IP Address Configuring for a Single Static IP Address Page Page Page Configuring for a Block of Static IP Addresses Page Page Page Page Page Advanced Setup Accessing Advanced Setup WAN IP Address Page Page Page Page Wireless Settings Page Page Page P Wireless MAC Authentication LAN IP Address DHCP Server Page Services Blocking Website Blocking Remote Management Port Forwarding DMZ Hosting M Firewall Dynamic Routing NAT (Network Address Translation) Static Routing Status Page Page Page Using Utilities Web Activity Log DSL Settings Restore Default Settings N Upgrade Firmware Page Setting Up a Network Ethernet Page Page Note: An Ethernet port looks similar to a phone port, but is Page Page USB Page Page Page Page Page Troubleshooting Page Page Page Reference A Locating Computer Information Locating Windows Operating System Files Page Page Static IP Address on the Computer B Windows 98 SE Page Page Windows Me Page Page Windows 2000 Page Page Page Windows XP Page Page Page Page Page Computer Security C Comparing DSL Service with a Dial-Up Modem Gateway Security Computer Security Electronic Security Page Specifications D General Wireless Operating Range LED Indicators Glossary E Page Page Page Firewall Security Level Services Table F High Security Level Medium Security Level Low Security Level Basic Security Level Service Acronym Definitions Page G Page Page Connecting to the ISP Page Page Notices Regulatory Compliance Notices Modifications Page Limited Warranty