Actiontec electronic GT701-WG N

4

Actiontec 54 Mbps Wireless DSL Gateway User Manual

5

Chapter 1 Introduction

Power Port

Used to connect the Power Cord to the Gateway.

N Warning: Do not unplug the power cord from the Gateway

during the reset process. Doing so may result in permanent

damage to the Gateway.

Technical Support

Self Help

To obtain answers to DSL configuration questions, visit the Qwest DSL Actiontec

support page at this address:

http://www.qwest.com/dsl/customerservice/Actiontecgt701-wg.html

A help page is also available on the main page of the Actiontec DSL Gateway Web

interface. Enter

192.168.0.1

in the browser’s address text box, and when the first screen appears, click HELP.

Basic Setup Support

If unable to access the Internet, look at the Internet light on the front of the

DSL Gateway. If the light is solid green, call the ISP immediately. If it is not solid

green, call Qwest at 1-800-247-7285.

Other Problems

Contact the ISP if experiencing problems with:

s DHCP addressing configuration

s Static IP addressing configuration

s Transparent bridging configuration

Contact Qwest at 1-800-247-7285 for:

s DSL service outage support and repair

Contents

Main Table of Contents 1 Introduction 1 2 Setting Up the Gateway 9 3 Using Qwest DSL 41 4 Basic Setup 43 Page Introduction Package Contents Minimum System Requirements Features Page Page N Technical Support Page Page Page Setting Up the Gateway Attention! Connecting a Computer to the Gateway Note: The following procedures are for U.S. installations only. Note: If I purchased my modem from Qwest was selected in Page Page Page Page Note: An Ethernet port looks similar to a phone jack, but is Page Page Page Note: If I purchased my modem from Qwest was selected in Page Page Page Page Page Page Installing Phone Filters M Caution: Do not unplug the green DSL cable from the phone M Caution: Do not plug a phone filter in the phone jack in which Page Note: You may have already unplugged this phone cord. M Caution: Do not unplug the green DSL cable from the phone Page Page Page Setting Up the DSL Connection Page Page Page Page Page Page Using Qwest DSL Connecting to the Internet Disconnecting from the Internet Page Basic Setup Basic Setup Page Page Page Setting Up Static IP Address Configuring for a Single Static IP Address Page Page Page Configuring for a Block of Static IP Addresses Page Page Page Page Page Advanced Setup Accessing Advanced Setup WAN IP Address Page Page Page Page Wireless Settings Page Page Page P Wireless MAC Authentication LAN IP Address DHCP Server Page Services Blocking Website Blocking Remote Management Port Forwarding DMZ Hosting M Firewall Dynamic Routing NAT (Network Address Translation) Static Routing Status Page Page Page Using Utilities Web Activity Log DSL Settings Restore Default Settings N Upgrade Firmware Page Setting Up a Network Ethernet Page Page Note: An Ethernet port looks similar to a phone port, but is Page Page USB Page Page Page Page Page Troubleshooting Page Page Page Reference A Locating Computer Information Locating Windows Operating System Files Page Page Static IP Address on the Computer B Windows 98 SE Page Page Windows Me Page Page Windows 2000 Page Page Page Windows XP Page Page Page Page Page Computer Security C Comparing DSL Service with a Dial-Up Modem Gateway Security Computer Security Electronic Security Page Specifications D General Wireless Operating Range LED Indicators Glossary E Page Page Page Firewall Security Level Services Table F High Security Level Medium Security Level Low Security Level Basic Security Level Service Acronym Definitions Page G Page Page Connecting to the ISP Page Page Notices Regulatory Compliance Notices Modifications Page Limited Warranty