HP 9470m i7 Win8 D3K33UT#ABA Power connector, a. Hard drive cover see Hard drive cover on page

2.Lift the touchpad from the computer (2).

3.Remove the touchpad.

Reverse this procedure to install the touchpad.

NOTE: When replacing the touchpad, make sure to install the screws into holes closer to the edge of computer.

Power connector

Description	Spare part number
Power connector	702875-001

Before removing the power connector, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 41), and then remove the following components:

a.Hard drive cover (see Hard drive cover on page 47)

b.Hard drive (see Hard drive/SSD drive on page 48)

c.Service cover (see Service cover on page 53)

66 Chapter 4 Removal and replacement procedures