5.Lift the base enclosure (1) off the computer while threading the antenna cables through the hole in the base enclosure (2).

Reverse this procedure to install the base enclosure.

Touchpad

Before removing the touchpad, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 41), and then remove the following components:

a.Hard drive cover (see Hard drive cover on page 47)

b.Hard drive (see Hard drive/SSD drive on page 48)

c.Service cover (see Service cover on page 53)

d.Keyboard (see Keyboard on page 60)

e.Base enclosure (see Base enclosure on page 63)

Remove the touchpad:

1.Remove the 2 Phillips PM2.0×3.0 screws (1) that secure the touchpad to the computer.

Component replacement procedures

65

Page 73
Image 73
HP 9470m i7 Win8 D3K33UT#ABA manual Touchpad