Pin 4

Line Lock

 

Pin 5

System Initialization (for

 

 

upgrade)

 

Pin 6

Reserved

RS-232 is reserved for internal use only; The Pin 3 and Pin 4, they are used for termination and Link Lock adjustment respectively. The Pin 5 is mainly used for return to factory default of camera setting.

3.Dome ID Setting

Use the switch to change your speed dome ID by turning the arrow to the desired number respectively. For instance, if the speed dome ID is 123, the ID switch should be set as below:

centesimal

decimal

single digit

NOTE: No two speed domes should be given the same ID, or communication conflict may occur.

NOTE: The number “0” should locate upwards as shown in

dabove diagram for correct switch definition.

o

4.Dome Control Protocol

Protocol is a specific set of rules, procdures used for data communications. Basing on the protocol of your management software that you are going to use. Use the switch to set your dome control protocol and the baud rate. Refer to table below and turn the arrow to choose a protocol for your speed dome.

Switch No.

Protocol

01Pelco D

02Pelco P

07DSCP

11Pelco D

12Pelco D

13Pelco P

Baud Rate

2400

4800

9600

4800

9600

2400

8

Page 13
Image 13
ACTiSYS CAM-6500 user manual Dome ID Setting, Dome Control Protocol