Mitsubishi Electronics FR-S500 instruction manual Flicker ... Parameter setting complete

1.

2.

3.

4.

5.

6.

Calibration parameters

Changing example Deflecting the meter (analog indicator) to full-scale (5V) at the preset frequency of 60Hz (for frequency setting, refer to the instruction manual (basic).)

POINT

•The calibration parameters "C1" can be made to be ready by setting "1" (extended function parameter valid) in Pr. 30 "extended function display selection".

•Set the value of the calibration parameter C1 "AM terminal calibration".

OperationDisplay

Press the MODE to choose the parameter setting mode.

Turn the to show

" " .

Pr. 30 must be set to "1".

(For details, refer to the instruction manual (basic).)

Press the SET to show

" " .

The parameter number read

MODE

previously appears.

SET

Turn the until the calibration parameter C1 "AM terminal calibration" appears.

Press the SET to enable setting.

If the inverter is at a stop, press the RUN to start it. (The motor

need not be connected.)

7. Turn the	to adjust the
indicator needle to the
desired position.
8. Press the	SET .

Setting is complete.

SET

RUN

RUN PU

EXT

+

Analog indicator

-

SET

Flicker ... Parameter setting complete!!

2

By turning the		, you can read another parameter.
Press the	SET	to return to the	indication (step 3).
Press the	SET	twice to show the next parameter (		).

REMARKS

•Depending on the set value, it may take some time for the needle to move.

•If "1" is set in Pr. 30 "extended function display selection", the calibration parameter C1 "AM terminal calibration" can also be set in the external operation mode.

•When the FR-PU04 is used, make calibration with Pr. 901.

FUNCTIONS

127