Mitsubishi Electronics FR-S500 Extended function display selection Pr, Frequency jump Pr, to Pr

Explanation of functions (parameters)

2.3.15 Extended function display selection (Pr. 30 )

Used to display the extended function parameters.

Refer to page 48 for the extended function parameter list.

Refer to the instruction manual (basic) for the parameter setting method.

Parameter	Name	Factory	Setting	Remarks
		Setting	Range
30	Extended function	0	0, 1	0: Without display,
	display selection			1: With display

2.3.16 Frequency jump (Pr. 31			to Pr. 36	)
When it is desired to avoid			Frequency jump
resonance attributable to the	(Hz)
natural frequency of a		Pr.36		3B
mechanical system, these	frequency	Pr.35
				3A
parameters allow resonant
frequencies to be jumped. Up		Pr.34		2B
to three areas may be set,		Pr.33
with the jump frequencies set	Running			2A
to either the top or bottom		Pr.32	1B
point of each area.		Pr.31
			1A
The value set to 1A, 2A or 3A
is a jump point and operation
is performed at this frequency.

Parameter	Name	Factory	Setting Range	Remarks
		Setting
31	Frequency jump 1A	---	0 to 120Hz,---
32	Frequency jump 1B	---	0 to 120Hz,---	• - - -: Function invalid
33	Frequency jump 2A	---	0 to 120Hz,---
				•Setting is enabled when Pr.
34	Frequency jump 2B	---	0 to 120Hz,---
				30 = "1"
35	Frequency jump 3A	---	0 to 120Hz,---
36	Frequency jump 3B	---	0 to 120Hz,---

<Setting>

•To fix the frequency at 30Hz between Pr. 33 and Pr. 34	Pr.34:35Hz
(30Hz and 35Hz), set 30Hz in Pr. 33 and 35Hz in Pr. 34.	Pr.33:30Hz
•To jump to 35Hz between 30 and 35Hz, set 35Hz in	Pr.33:35Hz
Pr. 33 and 30Hz in Pr. 34.	Pr.34:30Hz

CAUTION

During acceleration/deceleration, the running frequency within the set area is valid.

REMARKS

Write disable error " " occurs if the frequency jump setting ranges overlap.

80