Mitsubishi Electronics FR-S500 Standard connection diagram and terminal specifications, Nfb Mc

Standardconnection diagramand terminal specifications

1.1Standard connection diagram and terminal specifications

1.1.1Standard connection diagram

￿Three-phase 200V power input

￿Three-phase 400V power input

NFB MC

Three-phase AC power supply

External transistor common 24VDC power supply Contact input common (source)

Take care not to short terminals PC-SD.

	Forward rotation start
Control input	Reverse rotation start
signals			High speed
(No voltage	Multi-speed		Middle speed
input allowed)	selection		Low speed
	Contact input common
Frequency setting signals (Analog)
Frequency setting		3
potentiometer
			2
1/2W1kΩ *4

	Inverter
R/L1			U		Motor
					IM
S/L2			V
T/L3			W		Ground
			P1
PC				Power factor improving
				DC reactor
				(FR-BEL: Option)
			P/+	Jumper: Remove this
				jumper when FR-BEL
STF		*1 N/-		is connected.
STR *5		*2 PR
RH	*5	*6	A
RM	*5	*6	B
RL	*5			Alarm output
		*6	C
SD
					Operation status
		*6 RUN		Running
					output
			SE	Open	Open collector
				collector	outputs
10(+5V)				output
				common

2 0 to 5VDC Selected 0 to 10VDC

1

Current input(-)

4 to 20mADC(+)

When using the current input as the frequency setting signal, set "4" in any of Pr. 60 to Pr. 63 (input terminal function selection), assign AU (current input selection) to any of terminals RH, RM, RL and STR and turn on the AU signal.

5

(Common)

4 (4 to 20mADC)

SINK

*3

SOURCE

RS-485

Connector

AM (+)

Analog signal output

(0 to 5VDC)

5 (-)

Ground

Main circuit terminal Control circuit terminal

REMARKS

*1. The N/- terminal is not provided for the FR-S520E-0.1K to 0.75K-NA.

*2. The PR terminal is provided for the FR-S520E-0.4K to 3.7K-NA. (not used)

*3. You can switch the position of sink and source logic. Refer to page 23.

*4. When the setting potentiometer is used frequently, use a 2W1kΩ potentiometer.

*5. The terminal functions change with input terminal function selection (Pr. 60 to Pr. 63). (Refer to page 98.) (RES, RL, RM, RH, RT, AU, STOP, MRS, OH, REX, JOG, X14, X16, (STR) signal selection)

*6. The terminal function changes according to the setting of output terminal function selection (Pr. 64, Pr. 65). (Refer to page 100.) (RUN, SU, OL, FU, RY, Y12, Y13, FDN, FUP, RL, Y93, Y95, LF, ABC signal selection)

CAUTION

To prevent a malfunction due to noise, keep the signal cables more than 10cm away from the power cables.

2