Mitsubishi Electronics FR-S500 instruction manual Functions, Chapter Chapter

2. FUNCTIONS

This chapter explains the "functions" for use of this product. For simple variable-speed operation of the inverter, the factory settings of the parameters may be used as they are. Set the necessary parameters to meet the load and operational specifications. Refer to the instruction manual (basic) for the operation procedures. Always read the instructions before using the functions.

2.1	Function (Parameter) list	48
2.2	List of parameters classified by purpose of use	61
2.3	Explanation of functions (parameters)	63
2.4	Output terminal function parameters	86
2.5	Current detection function parameters	88
2.6	Display function parameters	90
2.7	Restart operation parameters	92
2.8	Additional function parameters	95
2.9	Terminal function selection parameters	98
2.10	Operation selection function parameters	101
2.11	Auxiliary parameters	120
2.12	Maintenance parameters	122
2.13	Calibration parameters	126
2.14	Clear parameters	129
2.15	Communication parameters	130
2.16	Parameter unit (FR-PU04) setting	151

CAUTION

As the contact input terminals RL, RM, RH, STR, open collector output terminal RUN and contact output terminals A, B, C can be changed in functions by parameter setting, their signal names used for the corresponding functions are used in this chapter (with the exception of the wiring examples). Note that they are not terminal names.

REMARKS

Parameter copy

Use of the parameter unit (FR-PU04) allows the parameter values to be copied to another FR-S500 series inverter. After batch-reading the parameters of the copy source inverter, you can connect the parameter unit to the copy destination inverter and batch-write the parameters.

For the operation procedure, refer to the instruction manual of the parameter unit (FR-PU04).

Chapter 1

Chapter 2

Chapter 3

Chapter 4

47